Step 1. If your device is not brand new you can skip this step. If you just bought your device, this video will help you figure out whats in the box and what to do with the red felt pads in the accessory kit. Note 1: New devices come with a little plastic battery saver protruding through the battery door on the back of the device - you should remove and discard this. Note 2: The newest devices will not have a yellow foam piece in the accessory pack - this is normal.

Step 2. Download and install the iOLab Application.

Step 3. This video will show you how to run and calibrate your iOLab system. The calibration values are stored on your computer, so this procedure needs to be done on each computer that you use the device with. Do not over-tighten when you screw something into the force probe.

Step 4. This video will show you how to analyze at your data and how to recall data from previous acquisitions.

Step 5. This video will show you how to share your data using the iOLab cloud repository. You should already have created a free account in the iOLab cloud repository by going to iolabrepository.azurewebsites.net and following the directions. You can access any data posted to the repository by going to the same the same website.